29
Intended Use
• The InductWarm® 130+ is designed to keep food warm in induction capable dishes. Other use can
destroy the system or the dishes.
• Only use dishes, which have been approved as induction compatible by the producer.
• The surface of the InductWarm® appliance should not be used for storage.
• Only use suitable pans with a minimum base diameter of 12 cm for induction warming. Theoretical,
it is possible to use smaller dishes, but this may result in the following:
– Reduced efficiency
– Pan recognition may not be possible
– Radiation may be greater
• Never heat a pan while empty. This could cause the pan to overheat.
• Once you have removed the pan after warming, remember to switch the InductWarm® 130+
appliance off, unless you intend to use it again straight away. This will prevent the appliance from
heating up accidentally should you or someone else place a pan on the warming surface.
• Do not heat up tins or other sealed containers, as these can explode! Items that are unsuitable for
use include any dishes that are not specifically intended for induction appliances, as well as metal
splash guards, aluminum foil, cutlery, jewelry, watches, metallic objects, etc.
• The induction hob is officially switched on as soon as the rotary switch is moved away from the off
position (red line aligned with status indicator). Whenever the hob is not in use, the appliance must
be switched off.
Troubleshooting
Error
Cause
Remedy
LED is not flashing
No power supply
Plug the appliance in,
check the plug connection
Power line fuse tripped
Check and reset the fuse
Appliance not switched on
Check the plug connection, turn on the
power switch on the bottom of the device
Appliance defect
Contact customer service
LED flashing
Pan is not detected
Pan too small or not
induction compatible
Infra-red remote control is not
working
Low Battery
Replace the battery
Sender or receiver are solid
Clean sender or receiver
No electrical contact between battery and
remote control
Ensure contact between battery and
remote control
Dish is not warming enough
Incorrect placement of dish
Ensure right position above the induction
coil
Too little energy input
Increase power level
Dish is not induction compatible
Check induction compatibility of dish
