24
25
Plug in the power supply.
The display shows the actual cabinet temperature.
.
Start-up:
Servicing: Make sure the applience is switched off at the mains
before service is performedon electrical parts.
Warnings: never use sharp or pointed objects as this may damage
the machine.
Setting the temperature
Defrosting
Temperature control
To view and change the setting:
- press SET for 1 s, the set value starts flashing ;
- Increase or decrease the value with the UP or DOWN button ;
- press SET to confirm the new value.
Refrigerator:
Defrosting takes place during periods when the compressor is not running.
The defrost water is collected in the channel under the evaporator then led through a
tube into the re-evaporation pan near the compressor.
Freezer:
Disconnect power at the mains and place a bowl of hot water in the cabinet. Close
the door and wait half an hour. Blowing hot air into the cabinet with a hair dryer can
accelerate the defrosting. The remaining frost can be wiped off with a warm cloth.
Troubleshooting
If the appliance does not work properly, check the following table before calling for
technical assistance.
Fault
Probable cause
Action
The appliance is not
working
The unit is not switched on
Check that the unit is plugged
in correctly and switched on
Plug and/or lead are dama
-
ged
Call a qualified technician
Fuse in the plug has blown
Replace the fuse
Power supply
Check power supply
Internal wiring fault
Call a qualified technician
The appliance works but
the temperature is too high
or too low
Too much ice on the evapo
-
rator
Defrost the appliance
Condenser blocked with dust Clean the condenser thorou-
ghly
Doors are not shut properly
Check that doors are shut and
seals are not damaged
Appliance is located near a
heat source, or air flow to
the condenser is blocked
Move it to a suitable location
Ambient temperature is too
high
Increase ventilation or move
appliance to a cooler position
Unsuitable foodstuffs are
being stored in the appliance
Remove any excessive hot
foodstuffs or blockages to the
fan
Appliance is overloaded
Reduce the amount of food
you need to store
