31
disc pokes out approx. 2mm of the front of the worm housing and the axis of the
worm pokes out 2 mm of the grinding disc.
Firmly screw the closing ring on the worm housing and tighten by hand.
ATTENTION:
Do not use any tools, for tightening the screw and pay attention not to cant
the screw. If the screw cants the screw thread gets damaged. If the screw does not
turn easily put some sunflower oil (or other edible oil) on the screw.
3. Firmly secure the worm housing in the opening for the
drive shaft. The small end of the worm housing has to
face the mincer (picture D). Incline the worm housing a
little bit to the right, when assembling it. When the worm
housing is fitted all the way into the opening of the drive
shaft the release button sinks into the motor housing. Turn
the worm housing counter clockwise until the shaft is facing
upright.
NOTE:
When the worm housing is securely attached you can
hear a click sound and the release button comes out of the
recess again (picture F).
4. Press the feed pan onto the worm housing (picture G).
5. Place the pusher into the opening of the feed chute (picture H).
The appliance is ready for operation.
Assembling for making sausages
1. Picture I: Take the worm housing into the right hand
and insert with your left hand the worm inside the
worm housing. The side of the worm with the plastic
end has to face the worm housing when putting it
inside the worm housing. If the worm is correctly
assembled when the plastic end of the worm pokes a
few millimetres out of the worm housing.
D
F
G
H
I
41406_designfleischwolfelectronicpro_manual_GermanEnglisch_neu.qxp 20.10.2009 11:00 Seite
Summary of Contents for 41406
Page 20: ...Notes...
