Gastro-M 60/30 BME, Installation, Use And Maintenance Manual, Page: 11 / 125

11
EMPTYING
- Turn the lever clockwise. The drain is fully open
when the handle is totally turned left. If is necessary
empty the tank more times.
- The 600 and 700 series equipments are provided
with frontal drain and drainpipe with bayonet cap.
BURNER IGNITION AND EXTINCTION
The gas tap control knob has the following
positions:
OFF
PILOT IGNITION
MAXIMUM WATER TEMPERATURE
INTERMEDIATE TEMPERATURES
MINIMUM TEMPERATURE
PILOT IGNITION
- Press and turn knob to “pilot on”.
- Press the knob down fully and light the pilot using
the piezoelectric igniter.
- Hold the knob down for about 20 seconds before
releasing it. If the pilot flame goes out, repeat the
operation.
- The pilot " ame can be seen through the peep hole
on the control panel.
- The pilot burner can be lit by passing a flame
through the bullseye on the bottom of the
appliance.
MAIN BURNER IGNITION
- Turn the knob to the chosen temperature setting
for cooking.
TURNING OFF
- To switch the main burner off, press and turn the
knob to position “pilot on”.
- To switch off the pilot flame, press and turn the
knob to position " Off " .
11. USING THE ELECTRIC BAIN MARIE
WARNING!
The appliance is designed for indirect cooking of
foods in cooking receptacles and for keeping food
warm in a bain marie.
Do not activate the heating system when there is no
water in the well.
While the appliance is on, the water level must be
maintained level with or above the minimum level
indicated on the wall of the well.
The appliance is equipped with a manual reset
safety thermostat that interrupts heating when the
operating temperature exceeds the maximum
permitted value.
At the end of each day, clean the well thoroughly in
order to prevent the formation of corrosive
deposits.
FILLING AND EMPTYING OF THE TANK
FILLING
- Insert the overflow pipe in the drain hole of the
well.
- Fill the tank up to the maximum level mark this on
the wall of the tank.
- Do not use the equipment with a water level higher
than the maximum level mark.
EMPTYING
- Remove the overflow pipe from the drain hole of
the well.
SWITCHING ON AND OFF
The control knob has the following positions of use: