OPERATING INSTRUCTIONS
Start a Vehicle Charge Session
Before starting a charge session:
Ensure the unit is properly assembled in accordance with the
assembly instructions before it is used.
You must have a RFID Card activated on backend server or being
connected to backend App.
Note: The RFID card MIFARE 1k is recommended.
1. A) Swipe an activated RFID card once across the card reader
or
B) Remotely start the charge through an application linked to the
backend
2. A) The unit will beep once indicating the card swipe was
successful
B) Wait for display indication
3. The display will show if the charge has been authorized
4. The display will instruct the user when to plug into the vehicle
5. Plug the connector firmly into the vehicle. The latch should click
6. Observe the display and charging will begin once the car
acknowledges the charger
Stop a Vehicle Charge Session
The charger will automatically stop once charging is completed.
Fast charging will occur up to 80% of the vehicles battery state
of charge. The charger will adjust its output according to the
demands of the vehicle, ambient temperatures and other factors.
To stop charging before the end of the charging cycle follow these
steps:
1. A) With the same card that the session was initiated with,
swipe over the card reader
or
B) Remotely stop the charge through an application linked to the
backend
2. The display will indicate that the session is ending
3. Once the session has ended the vehicle will unlock the
connector. A click may be heard at the vehicle/connector
4. Once unlocked, remove it from the vehicle charging inlet
5. Return the connector to the dock on the charging station
Emergency Stop
In the event of an emergency the Emergency Stop button may be
depressed to instantly stop charging.
To emergency stop follow these steps:
1. Depress the emergency stop button bellow the charger
2. The display will show the text “Error occurred: 0x02 Emergency
stop was launched. Please unplug your
vehicle and check the emergency button is released.”
3. Unplug the connector from the vehicle
To reset after emergency stop rotate the button clockwise until it
pops outward. After a self-test the display will
remove the emergency stop message and will be ready for a new
session.
Human/Machine interface (HMI)
UTILIZATION
Note: Also applicable in CHAdeMO and AC type 2.
Charger states
• Available: Connector available
• Preparing: Charge preparation
• Finishing: Charge ending or ended but connector still connected
to the vehicle
• Unavailable: Connector unavailable
• Error: An error has occured
Color code
23
EN
