5. Pass the power cable through the input cablegland into the
housing.
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC
FLASH
Be sure the supply power is off before starting installation.
Make sure nobody can switch on power during
installation.
Failure to follow these instructions can result in death or
serious injury.
6. Remove 15mm of insulation from the end of the power cable to
be connected to the internal circuit breaker.
7. Connect ground wire to connection terminal block.
8. Connect neutral to connection terminal block if necessary.
9. Connect each phase to connection terminal block.
HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC
FLASH
Theses steps must be done with external circuit breaker
switched off.
Failure to follow these instructions can result in death or
serious injury.
EN
18
