Adjusting the Tones
1 Select >
> >
> Zone.
2 Select a zone.
3 Select TONE.
4 Use the slider bar to adjust the level of each tone.
Disabling the Loud Setting for a Zone
The Loud setting maintains frequency response at low volumes and increases perceived loudness at high
volumes. This setting is enabled by default in all zones.
1 Select >
> >
> Zone.
2 Select a zone.
3 Select Loud to clear the check box.
Adjusting the Gain for an Auxiliary Device
You can adjust the gain for a connected auxiliary device to achieve a volume level similar to that of other media
sources. You can adjust the gain in 1 dB increments.
1 Select an auxiliary source.
2 Move the slider left or right to increase or decrease the gain.
NOTE: to achieve the best audio quality when using a portable media player with headphone output, it may
be necessary to adjust the volume control on the media player, instead of adjusting the gain.
Speaker Zones
You can group speakers in one area into a speaker zone. This enables you to control the audio level of the
zones individually. For example, you could make the audio quieter in the cabin and louder on deck.
You can set the balance, volume limit, tone, subwoofer level, subwoofer frequency and name for each zone, and
configure other zone-specific settings (
Speaker Zone Settings, page 50
).
Adjusting the Audio Settings for a Zone
1 Select >
> >
> Zone.
2 Select a zone.
3 Select More.
4 Select one or more options:
NOTE: not all options are available for all zones.
• To limit the maximum volume output of this zone, select Volume Limit and adjust the level.
• To set the subwoofer level for this zone, select Sub Level, and adjust the level.
• To adjust the right and left speaker balance of this zone, select Balance and adjust the balance.
Adjusting the Subwoofer Filter
You can use the subwoofer filter setting to control the subwoofer cut-off frequency for each zone, which can
enhance the blend of the sound produced by the speakers and the subwoofer. Audio signals above the selected
frequency are not passed to the subwoofer.
NOTE: if a DSP setting has been applied to zone, this setting cannot be changed on the stereo. You can view the
DSP setting for the optimal cut-off frequency as calculated by the DSP controller, but cannot adjust it.
1 Select >
> >
> Zone.
2 Select a zone.
3 Select SUB FREQ.
4 Select a frequency.
Music Playback and Stereo Features
37
Summary of Contents for VIEO RV 1050 Series
Page 1: ...VIEO RV850 RV1050SERIES Owner smanual ...
Page 8: ......
Page 81: ......
Page 82: ...support garmin com GUID F2A144DD 76F7 44EF AADF 270AAAC241A9 v3 December 2021 ...