9-36
Garmin GTN 725/750 Pilot’s Guide
190-01007-03 Rev. D
Foreword
Getting
Started
Audio &
Xpdr Ctrl
Com/Nav
FPL
Direct-To
Proc
Charts
Wpt Info
Map
Traffic
Terrain
Weather
Nearest
Services/
Music
Utilities
System
Messages
Symbols
Appendix
Index
9.4 CDI (GTN 750 only)
The GTN 750's
CDI
key is used to select data that is sent from the GPS
or VLOC receiver to the external CDI (or HSI). When the external CDI (or
HSI) is connected to the GPS receiver, “GPS” appears below the
CDI
key in the
annunciation bar. When the external CDI (or HSI) is being driven by the VLOC
receiver, “VLOC” appears instead.
NOTE:
The VLOC receiver must be selected for display on the external CDI/
HSI for approaches which are not approved for GPS. See the ILS example
in the Procedures section for more information.
NOTE
: GPS phase of flight annunciations (LPV, ENR, etc.) are not applicable
to the external CDI (or HSI) when VLOC is active.
NOTE:
The internal on-screen CDI information is based on GPS data and
cannot be used for primary navigation.
NOTE:
If the unit is not configured for a CDI key, then the “activate GPS missed
approach” will only resume automatic waypoint sequencing. The user must
switch to GPS navigation, if desired, by using their external source selection
method (this is typical an EFIS system).
1. The navigation source is annunciated under the
CDI
key.
Touch
CDI
Key To Toggle
Navigation Source
Navigation Source
Annunciation
Figure 9-42 Navigation Source Selection
2. Touch the
CDI
key to toggle between sources.
Summary of Contents for GTN 725
Page 553: ......
