Page 5-14
500 SERIES INSTALLATION MANUAL
Page Rev. B
P/N 190-00181-02
5.2.16 TRAFFIC Page
(Only if 500 Series unit configured for BFG Skywatch or Ryan TCAD interfaces)
Select the TRAFFIC Page (see Figure 5-15). This page
shows the BFG Skywatch or Ryan TCAD modes of
operation and current traffic situation.
For BFG Skywatch, this page shows:
1.
The altitude mode—below (BLW), normal (NORM),
above (ABV), or unrestricted (UNR)
2.
The operating mode—standby (STBY) or operating
(OPER)
3.
Current altitude (ALT)
4.
Altitude limits being imposed (LIM A and LIM B)
5.
Heading, and barometric (BARO) and radio (RAD)
altitude status.
For BFG Skywatch (see Figure 5-15), verify that the 500 Series unit can change the Skywatch operating
mode (STBY or OPER). In standby mode, verify that the Skywatch may be placed in self-test mode by
highlighting “Test Mode?” and pressing ENTER on the 500 Series unit. Refer to the BFG Skywatch
installation manual for system checkout.
For Ryan TCAD (see Figure 5-16), this page shows the
current shield mode and altitude. Verify that the TCAD
shield mode may be changed—Ground (GND), Terminal
(TML), Standard (STD), En Route (ENR), or Unrestricted
(UNR), and that the TCAD is reporting the correct altitude.
Refer to the Ryan TCAD installation manual for system
checkout.
5.2.17 RYAN TCAD CONFIG Page
(Only if 500 Series unit configured for Ryan TCAD interface)
Select the RYAN TCAD CONFIG Page (see Figure 5-17).
This page shows the TCAD’s current shield settings for the
selected mode, approach mode status, volume, mute status,
mute duration, voice alert selection, and system status.
Verify that the TCAD system status is GREEN. Also,
verify that shield settings and volume, mute duration, and
voice alert selection can be modified. Verify that changes
in mute (if a mute switch is installed) are shown. Refer to
the Ryan TCAD installation manual for system checkout.
Figure 5-15. TRAFFIC Page (Skywatch)
Figure 5-16. TRAFFIC Page (TCAD)
Figure 5-17. RYAN TCAD CONFIG Page
