190-02246-11
GI 275 Part 23 AML STC Maintenance Manual
Rev. 1
Page 5-25
Figure 5-15 VFR GPS Antenna Installation (Removable Installation Example)
5.10.1 VFR GPS Antenna Removal
Use the following procedure to remove the VFR GPS antenna:
1. Remove power from the GI 275 connected to the VFR GPS antenna.
2. Disengage the BNC connector from the GI 275.
3. Remove the two screws securing the antenna (if installed per Figure 5-14 only).
4. Lift up on the VFR GPS antenna to remove it.
5.10.2 VFR GPS Antenna Re-installation
Install the VFR GPS antenna in the reverse order of the removal procedure.
5.10.3 VFR GPS Antenna Checkout
Perform the Backup GPS Signal Check as described in Section 6 of
GI 275 Part 23 AML STC Installation
Manual
(P/N 190-02246-10) or
GI 275 EIS & MFD Installation Manual
(P/N 190-02246-14).
2.0
1
1
2
1
3
1
REF. GLARE SHIELD,
INSTRUMENT PANEL
EXISTING
2
2
2
NOTES
DIMENSIONS ARE IN INCHES UNLESS OTHERWISE SPECIFIED.
1.
2
PEEL OFF ADHESIVE PROTECTING FILM AND PRESS THE FASTENER TAPE IN TO BOND. SURFACES MUST BE CLEAN AND FREE
FROM OIL OR OTHER CONTAMINANTS. LOOP FASTENER IS BONDED TO GLARE SHIELD AND HOOK FASTENER IS BONDED TO
ANTENNA. TAPE FASTENER MUST BE 2.0 INCHES OR LONGER.
3 GPS ANTENNA KIT, GARMIN PART NO. 010-12444-00 INCLUDES DUAL LOCK FASTENER, GARMIN PART NO. 252-00433-00
WHICH CAN BE USED INSTEAD OF A-A-55126 FASTENER TAPE.
QTY ITEM PART NUMBER
DESCRIPTION
1
3
A-A-55126 3
FASTENER TAPE, SYNTHETIC, ADHESIVE BACKED, A-A-55126 CLASS 1/2, TYPE 1, LOOP 1.0 INCH WIDE
2
FASTENER TAPE, SYNTHETIC, ADHESIVE BACKED, A-A-55126 CLASS 1/2, TYPE 1, HOOK 1.0 INCH WIDE
1
1
011-04036-
0
BACKUP GPS ANTENNA
