190-02246-11
GI 275 Part 23 AML STC Maintenance Manual
Rev. 1
Page 2-6
2.3 Configuration Mode Operation
2.3.1 Entering Configuration Mode
The Configuration mode of the GI 275 can be accessed by holding down the inner knob located at the
bottom-left of the unit upon initial power-up. The knob must be pressed until the splash screen shown in
Figure 2-2 appears. Touch
Accept
to proceed to the Configuration mode home page
.
Figure 2-2 Entering Configuration Mode on the GI 275
2.3.2 Wireless Connectivity
The GI 275 is capable of connecting to Wi-Fi and Bluetooth via the Garmin Pilot application to update
flight databases. Refer to Section 5.14 of
GI 275 Part 23 AML STC Installation Manual
for procedures.
2.3.3 Import Configuration
Configuration settings can be imported via USB using the following procedure:
1. Power the GI 275 and all LRUs in the system on in Configuration mode.
2. Insert the USB drive containing the configuration files into the USB dongle or GSB 15 (if
installed). A USB icon should appear on the left of the display once the GI 275 has recognized the
device. If the icon doesn’t appear after 1 minute, remove the drive and re-insert it.
3. Navigate to the
Config Options
page (
SW/Config
→
Config Options
).
4. Touch the
Import Configuration
button.
5. Touch the
Select Files
button and select the configuration file to be imported.
6. Touch the
Select Configuration
button.
7. Select the applicable configurations and then touch the
Back
button.
8. Touch the
Import Config ( )
button and then touch the
Start
button.
