![background image](http://html1.mh-extra.com/html/garland/sh-3500-555/sh-3500-555_installation-operation-and-maintenance-manual_3679164034.webp)
34
Part Number 4532879 1/15
Operation
Section 3
Power Control
Set the desired power level by turning the control knob and
the unit is immediately ready for operation. When the green
indicator lamp lights up continuously, energy is being
transferred to the cookware.
ON-Position
Any position
other than “0”
is pointing
to the LED
indicator
light. The LED
is on.
OFF-Position
“0” is pointing
to the LED
indicator
light. The LED
is off.
Set and adjust the power level by turning the control knob:
• Position (1) indicates minimum power.
• Position (12) indicates maximum power.
POWER DIAGRAM
The following Power Diagram shows the difference in
power output between two higher power levels is much
larger than that between two lower power levels.
The settings from (1) to (9) span the lower 50% of the total
Power Output; the settings from (10) to (12) cover the 50%
to 100% output range.
This power level and output relationship provides a fine
simmer-rate control in the low power range, and instant
response in the high power range.
POWER
OUTPUT
P O W E R D I A G R A M
0
1
2
3
4
5
6
7
8
9
10
11
12
P O W E R LEVEL
100%
50%
10%
20%
30%
40%
60%
70%
80%
90%
No Pan No Heat
When a temperature is chosen, the induction unit only
transmits energy when a pan is placed in the heating
zone. If you remove the pan from the heating zone, power
transfer to the pan stops immediately. If the pan is put back
in the heating zone, power is transferred to the pan again.
Note the signals given by the green indicator lamp:
• The green indicator lamp flashes when the unit is ON
but without any pan placed on the hob; the unit is in
pan detection mode.
• As soon as a pan is put on the hob, the heating process
is engaged and the indicator lamp stops flashing and
remains bright. However, the indicator lamp will keep
flashing if the unit is unable to detect the pan or an
unsuitable pan is placed on the glass-top.
NOTE: Pan with a bottom diameter smaller than 5”(12 cm) is
not detected by the system.
When Unit Is Idle
Best Praitiie:
If the induction unit is not in use, ensure the control knob is
in the 0 (OFF) position.
Notiie
Switch the unit OFF if you take the cookware away for
a while. This will prevent the heating process to start
automatically and unintentionally when a pan is placed
back on the heating area. If any person needs to use
the induction unit, he/she will have to turn the unit ON
intentionally.
Summary of Contents for SH 3500-555
