Garland SH 3500-555, Installation, Operation And Maintenance Manual, Page: 18 / 44

18 Part Number 4532879 1/15
Installation Section 2
GEERAL DESIG CRITERIA
otice
Components of the structure made from steel in the
vicinity of the coils must not be magnetic.
If two coil carriers are installed in the same frame, a
partitioning plate made from non-magnetic steel must
be installed between the coil carriers.
• For all critical information regarding glass-top
dimensions and installation, refer to section “Glass
Installation Guidelines and Instructions” on page 23
• The generators should be accessible and removable
for service and maintenance. Note that all electrical
connectors are located on the front panel of the
generator.
• Features on the induction unit designed for installation:
A. Support Rails: There are support rails on each long
side of the unit. To install the unit, support these
rails on a mounting structure.
B. Locating Tabs: There are locating tabs at front of
the support rails for positioning the unit. In your
design, include slots or holes to insert these tabs.
Refer to the technical drawings of the compact line
generators for the exact locations of these tabs.
B
A
• Illustration below shows a quad configuration with a
support frame.
A
B
• It is desirable to include height-adjustable feature to
level the unit during installation.
• Use 10- to 14-gauge non-magnetic metal (typical12-
gauge) for the mounting frame.
• The mounting frame should not interfere with the air
intake duct (provided in the air intake kit) or block the
air vents on the unit.
• Depending on the thickness and material of the
counter-top, additional reinforcement structure may
be required. Consult your counter-top supplier for
information.