GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATEN
PART #4527466 (12 Aug 2011)
Page 35
This procedure for placement of meat products on the clamshell grill must be followed exactly. Place patties on the lower
grill plate
2 at a time, from front-to-back, and right-to-left
, positioned as shown in the diagrams below. (Each square
represents one cooking lane; the area beneath one upper platen.)
When cooking is complete, the upper platen will raise automatically. Immediately after the platen raises, season the
meat, (if applicable), then remove the patties in the same order they were loaded
one at a time. It is important that the
unload sequence is identical to the load sequence.
10:1 ONLY
1
1
1
1
1
1
1
1
1
1
1
1
1
2
2
2 2
2
2
3
4
4
4
3
3
3
3
3
3
2
2
2
2
2
2
1
NOTE:
Patty placement procedure may vary outside of North America. Please consult your local McDonald’s management.
OPERATING PROCEDURES
(continued)
PATTY PLACEMENT
LONWORKS INFORMATION
Lunch In Auto mode
Note:
Switching from breakfast to lunch menu items will
take approximately 10 minutes to heat to the appropriate
temperatures.
1. Select PM mode. Press and hold the
button.
2. Select Auto mode. Press and hold the
button. The
control will display “PM / AUTOMATIC.”
3. Following the lay patterns shown on the following
page, load product on the grill.
4. Press
the GREEN or (
GREEN &
BLACK) push-
button(s) to initiate a cook cycle. The platen will lower,
and recognize the product that has been loaded on the
grill.
5. Alarm will sound when the cook cycle is complete
6. Remove product and clean grill to prepare for next
cook cycle.
Transition Cooking
Approximately 30 minutes before changing to the lunch
menu, perform the following:
1. PRESS the
button (to display the upper platen
temperature).
2. Press the
button.
3. The upper platen indicator will turn on. The upper
platen will heat to 425 degrees F (217 degrees C)
the platen will maintain this set temperature unless
another menu item is selected.
To Shutdown Grill
Turn Main Power Switch OFF to disable all burners. For
extended periods of shutdown, turn Main Power Switch
OFF, close and disconnect main gas and/or electrical
connections.
LonWorks lets manufacturers and integrators create and implement control solutions for customers all over the world.
With LonWorks, you can embed intelligence and communications into any device with an electronic heartbeat, and then
network these devices so they can work together to sense, monitor, and control. Their embedded intelligence allows them
to work without a master controller or PC, and work with enterprise applications and other services.
This LonWorks gateway is a “Smart Equipment” networking solution for McDonalds. LonWorks allows us to use existing
power lines to transmit the data rather than the use of Ethernet cabling. The LonWorks gateway will collect information
from the grill and transmit it into a computer elsewhere. Capable and authorized users will be able to collect this
information and monitor the data from a centralized location. LonWorks enabled or smart equipment will have not only
the capability of being monitored, but programmed and set up as well.
Summary of Contents for MWE1S
Page 2: ......
