INSTALLATION/OPERATION & SERVICE MANUAL - 1&2 PLATEN
GARLAND CLAMSHELL GRILLS WITH PRODUCT RECOGNITION
PART #4527466 (12 Aug 2011)
Page 58
TO REPLACE THE SHAFT SEALS & CAP O-RINGS
(continued)
9. Once all of the
mechanical com-
ponents have been
reassembled (re-
move tools or any
other objects from
grill), turn main
power switch to
the On position.
The platen will
raise to the up po-
sition.
10. With the seal cap still not tightened down
completely, wear the new seal in by lower-
ing and raising the platen at least twice by
pushing the Green button.
11. Finally tighten
the seal cap down,
gentle tight.
TO UPDATE CONTROL SOFTWARE (main control)
THE FOLLOWING INSTRUCTIONS ARE FOR USE WITH THE GARLAND ZIPGRADER TO UPLOAD NEW
CONTROL SOFTWARE INTO WATLOW CONTROL (PN 4526975) AND WATLOW MOTOR CONTROL (PN
4521682).
To connect and up-
grade main control
(pn 4526975)
1. Remove upper
pushbutton panel
and lower control
panel.
a. Remove upper
panel screws to
release panel.
b. Carefully lower
panel and place
it on fl oor.
c. Do not disconnect main power switch
plug for later use.
2. Attach RJ12 - 6
conductor Modular
Telephone Cable to
ZipGrader & Con-
trol.
a. Attach one end
of cable to Zip-
Grader.
b. Attach opposite end of cable to control-
ler. Control jack is on the bottom side of
the controller.
Summary of Contents for MWE1S
Page 2: ......
