Garland moisture+ MPGD10D, Service Manual

Page: 25 / 80

Part # MPSM07 (03/24/08) Page 25
Display Messages
The display will be blank if the oven has been Off longer than 30
seconds .
This is the message that is displayed when the On/Off key is pushed
and the unit is powering down . This message is displayed for 30
seconds before going blank . It is also displayed when the Auto Cool
Down function shuts off .
This is a warning message shown when the oven cavity temperature
exceeds the programmed temperature by more than 25ºF . The actual
temperature and programmed temperature are also displayed .
This is the warning message shown when the oven cavity
temperature exceeds 575ºF . All oven function is shut down and the
user must remove power from the oven to reset the control after
correcting the error . The audible alarm will sound continuously .
If the control senses that the cavity probe shorts out or goes to an
open circuit this message will be displayed and the audible alarm will
sound continuously .
Repeat steps 4 through 7 for each individual shelf
position/shelf timer key that will be used .
9 . After programming all the shelf timers that will be used,
press the Program key . This will return the oven to idle
mode .
Cooking with shelf timers:
1 . Press the numeric key corresponding to the desired
profile, (fan setting, temperature and time; see ‘To
program shelf timers:’ on the previous page) . Allow the
oven to heat to the programmed temperature . When the
programmed temperature has been reached, the display
will indicate READY .
2 . Load product on the desired shelf, close the door, and
press the same key that was pressed in Step 1 . The display
will indicate ENTER SHELF .
Press the numeric key, (1 - 6), corresponding to the shelf
loaded . Press the Start/Cancel key to engage the timer
countdown for the selected shelf .
3 . Repeat Step 2 up to five times while loading the remaining
shelves .
Note: The display will show only one timer countdown at a
time. The shortest, (time remaining), of all the active shelf
timers will be displayed.
4 . When the shortest of the active shelf timers has expired,
the display will indicate DONE SHELF X, where X equals
the number of the shelf timer that has expired, and an
audible alarm will sound continuously for 10 seconds . The
LED on the expired timer’s key will flash . Press that timer
key to cancel the alarm, unload the finished product from
the corresponding shelf immediately and close the door .
The timer display will change to show the countdown of
the shortest of the remaining active shelf timers . Repeat
this step until all of the active timers have expired and
their respective shelves are unloaded .
If the alarm is not canceled after sounding continuously
for 10 seconds, it will sound a short tone once every 15
seconds until the corresponding shelf timer key is pressed .
The display will continue to indicate SHELF X and the
timer key’s LED will continue to flash .
If an alarm isn’t cancelled before the next timer expires,
the alarm will sound continuously and both keys’ LED’s
will flash . The display will continue to show the first
expired shelf timer number indicating the first shelf to
be unloaded . Cancel the displayed timer by pressing the
corresponding shelf timer key once, then unload the shelf .
The display will indicate Shelf X, where X is the number of
the next shelf to be unloaded . Expired, uncanceled shelf
timers will continue to be displayed in the order of their
expiration as each previous timer is cancelled .