Page 16 | HEEGM Service Manual part# 4532502 (Rev 0)
6 REMOVE, INSTALL AND ADJUST COMPONENTS
6.1 Knob
Each knob is connected to the gas valve extension
and is secured with a set screw on the left side.
Use a flat screwdriver to loosen or tighten the set
screw.
Set Screw
Valve Extension
Knob
6.2 Valve Panel
Remove the valve panel to gain access to:
•
wire channel, ignition wires, and electrodes
•
front manifold, gas valves, and spigots
• grease
chute
•
solenoid wires in B/X cable
i
IMPORTANT
To remove the side manifolds and solenoid valves, you will need to
remove BOTH the valve panel AND the Left Side Leg Panel.
To remove the valve panel:
WARNING
Remove all power supplies to the unit before opening panels for
servicing.
1. Take off the knobs.
2. Remove screws from the four corners as shown.
3. 48” and 60” Only: remove two screws at the bottom as shown.
4. 60” Only: take off the condiment rail support bracket as well.
A 60” Model Shown
View Bracket from
Underneath
2
2
2
2
3
4
1
Summary of Contents for HEEGM48CL
