UP FOLDING WALL MOUNT
12
INSTALLING THE BACKBOARD WITHOUT A HEIGHT ADJUSTER
Raise the arms to as close to level
as possible and support the outer
portion of the lower extension
arms with the scissor lift or
scaffolding.
Attach the lower corners of
the backboard to the lower
extension arms first to help
stabilize the backboard while
attaching the upper arms.
Attach the back board to the
board hinge mounts using the
appropriate board mounting
hardware. Make sure the chain
attach brackets are between the
upper board mounting point and
the upper hinge bracket.
Note, a glass board and carriage bolt hardware is
shown. Other style of board may require different
hardware.
Attach the turnbuckle to the chain attach plate with a
5/16” quick link. Attach the loose end of the chain to
the turnbuckle using a quick link.
Check to make sure each side of the frame is still square to the wall. Measure the distance from the
wall to the face of the back board on each side. Loosen the set screws in the outer tubes and slide the
inner extension arm in or out until the face of bank (FOB) is reached. Once both sides of the
backboard are at the correct FOB and the frame is still square to the wall, tighten the set screws.
Install the locking bolts on the extension arms the prevent movement
of the arms.
Drill a 7/16” hole through the inner extension tube using the hole in
the outer tube as a guide.
Install the 3/8” bolt (Item 26), locknut (Item 30) and tighten securely.
Repeat the process on all four extension tubes.
