UP FOLDING WALL MOUNT
13
Slide the pull up tube on the upper
extension arms until the center of the tube
is Dim “C” from the upper wood pad.
Make sure the tube is parallel with the face
of the backboard.
Tighten the clamp bolts on the tube clamps
securely.
Drill a small pilot hole in the side of the inner
extension tube and insert the ¼” self-tapping screw
just behind the clamp and on the wood pad side of
the clamp. Do this on both sides of the pull up tube.
These self- tapping screws will prevent the pull up
tube from slipping back when the unit is being
raised.
Route the loose end of the cable through the #5
Pulley and to the hoist. Refer to the hoist
installation section of this manual for locating and
installing the hoist.
Recheck all fasteners for tightness and security.
The final step of the assembly is to level the frame
extension arm by adjusting the chain tension with
the turnbuckles. It is important to not over adjust
the chains as this causes undue stress on the chain
anchor points. Chain tension should be no more
than enough to level the side frame tubes.
