MOUNTING
OUTDOOR USE ONLY! (Dom Etre Installe a l’Exterieur)
Impressionist Series
LED Wall Wash Light (CIWL6)
SAVE THESE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
Old world craftsmanship . . . today’s technology
®
Wall Wash (CIWL6)
Applies to CIWL6
Important. The lead wire for this fixture comes with Control Plug
detached. This allows the installer to pass wire through bracket and/
or mounting options such as Stake Mount (CWL8KIT) and Stake/
Stem Mount (CWL9KIT). After fixture is assembled with the selected
mounting kit, installer attaches Control Plug Assembly. Do not oper-
ate fixture with plug detached.
1. Bracket Mounting Instructions.
CAST Impressionist LED Wall Wash Light (CIWL6) includes copper mount-
ing bracket. Bracket can be used to mount fixture on any surface.
• Use provided (2) stainless steel flat Philips-head wood screws to secure
bracket to surface. If fixture lead wire interferes with flush-mounting then
push bracket’s anti-chafing plug back towards fixture to release wire. Pull
wire through bracket.
• Position fixture to ensure proper aiming. Mark screw hole locations with
marker.
• Disconnect bracket from fixture by removing (2) thumb screws. Screw
bracket onto surface. Re-attach bracket to fixture. Tighten thumb screws.
2. Canopy Mounting Instructions.
Use Wall Wash Canopy Mounting Kit (CWL7KIT) (purchased separately) for
mounting fixture to any surface to provide an offset of about 6” from sur-
face to fixture body.
• Before attaching mounting kit to Wall Wash bracket, insert end of fixture
lead wire into kit stem and feed through to exit kit bottom. Pull wire com-
pletely through until it stops.
• Disconnect bracket from fixture by removing (2) thumb screws. Using pro-
vided kit screws, secure kit flange to fixture bracket. Re-attach bracket to
fixture. Tighten thumb screws.
• Secure canopy to surface using provided screws.
3. Stake Mounting Instructions.
Use Wall Wash Stake Mounting Kit (CWL8KIT - short stem; CWL9KIT - long
stem; CWL9EXKIT - extendable stem) (purchased separately) for mounting
in turf or mulch bed regions.
• For all mounting kits, follow first three steps in Canopy Mounting
instructions (above).
3a. CWL8KIT Instructions: This kit comes with short stem and stake.
Stake must be installed in firm solid ground with top flange of stake level
with ground. If ground is not firm, then dig hole and backfill with mixture
of pea gravel and soil.
• Stake can be removed from fixture so it can be driven into ground with
rubber or dead blow mallet. If stake is not removed, do not put pressure
on fixture body when inserting into ground (as this may bend the bracket).
3b. CWL9KIT & CWL9EXKIT Instructions: The CWL9KIT kit comes with
a long stem and Large Talon Stake. The CWL9EXKIT comes with a long
extendable stem and Large Talon Stake. For both kits, follow Large Talon
Stake instructions (next page).
Green
Green
Yellow
10-24V AC/DC
Power - Black &
White Wires
(Polarity
Independent)
Tool Required
Heat Gun
CAST #18/4
No-Ox
®
Wire
to Fixture
Yellow
Control Plug Assembly
After passing wire through
bracket or mounting kit:
1. Firmly insert green and
yellow pins into plug -
yellow pin must insert into
pointed end of plug.
2. Slip heat shrink tube over
plug until end is lined up
with top of plug.
3. For best results, use 120V
heat gun (not torch - can
damage connection) to
shrink tube on all sides until
tight.
4. Place rubber cap over plug.
Line up
heat shrink
with plug
top.
