Page
6
GARDTEC
800 Series
User Manual
Setting The System
1)
With the display showing:-
2)
Enter your
User
code.
(Followed by YES if a
Master
or
Main
type code
has been used). The display will show:-
and a continuous exit tone will sound.
(See “Pre Exit Check” note below).
Note:
Count down in display is dependant on the setting mode programmed by the Engineer.
3)
Exit the premises via the authorised exit route.
(The exit tone will change if any detectors are violated during exit).
4)
Once the premises are secure listen, (from outside
the protected area) that the exit tone returns to the
continuous tone.
5)
Wait until the exit tone finishes before leaving.
Note:
Setting the system with an area code will set only the area(s)
associated with that code. (872 only).
Note:
Setting an unset system with a cleaner code will set the full system.
Pre Exit Check
At the start of the setting procedure any non exit routes that
are open will sound a fault tone. The display will show, for
example:-
If the fault clears within 20 seconds then the exit will begin,
otherwise the display will return to Day (Unset) Mode.
Setting & Unsetting the
System via a Keyswitch
One of two types of keyswitch(es) may have been fitted to your system.
Normal
To set the system with a normal keyswitch, insert the key and turn to the ON position
then remove the key. To unset insert the key and turn to the OFF position.
Biased
To set the system with a biased keyswitch, insert the key and turn it then return the key
to the original position and remove. To unset repeat this operation.
EXIT ! 1
All Zones ON 15
01 JAN 18 : 58 : 01
Time will count down
Zone 008 12hr
All Zones ON
PR5893 8.qxd 22/05/2006 11:14 Page 6