Page
46
GARDTEC
800 Series
User Manual
Programming ACE
Keyfobs onto your System
Each keyfob will occupy a User number. The number of keyfobs that may be used is
limited by the maximum number of user codes available on the system up to a
maximum of fourteen.
1)
Follow the procedure for programming user codes to the point when the user
code is entered.
2)
Point the keyfob at the ACE unit and press the button on the fob.
3)
Repeat this procedure for any other fobs you wish to be programmed using
a
different user number
each time (e.g. User 1 or User 2 etc.) each time.
4)
If more than one ACE receiver is fitted fobs need to be programmed onto all
ACE receivers,
retaining the same user number for each individual fob
.
Note:
When programming the fob onto more than one receiver (on the same
system) the button on the fob MUST be held down continuously
between programming onto the first and other ACE receivers.
Note:
In all cases when the ACE is used only Master & Main user levels will
allow part setting via the keyfob. Other code levels will only allow part
setting in conjunction with the keypad.
PR5893 8.qxd 22/05/2006 11:14 Page 46
