![background image](http://html1.mh-extra.com/html/gardner-denver/vs-11/vs-11_operating-and-service-manual_3888942021.webp)
13-18-606 Page 20
Before removing the oil filler plug, always stop the unit and release air
pressure, lockout and tagout the power supply to the compressor package.
Failure to release pressure or properly disconnect the power may result in
personal injury or death.
2.
Air Filter
- Inspect the air filter to be sure it is clean and the assembly is sealed tight. Refer to Section 7, “Air
Filter”, for complete servicing instructions. Be sure the inlet line is clean and sealed tight.
3.
V-belt drive
- Check hub screws for tightness and belts for proper tension. Refer to Section 8.
4.
Piping
- Refer to Section 2, “Installation,”
and make sure piping meets all recommendations.
5.
Electrical
- Check the wiring diagrams furnished with the unit to be sure it is properly wired. See Figure 4-3
thru Figure 4-6, pages 31 thru 34 for general wiring diagrams and Section 2, for installation instructions.
Make sure to check the wiring of the optional compressed air dryer, as it is serviced by an independent
electrical power feed.
6.
Grounding
- Equipment must be properly grounded according to Gardner Denver Guidelines for proper
wiring, grounding and feed power conditioning.
Failure to properly ground the compressor package could result in controller
malfunction.
N
N
N
O
O
O
T
T
T
I
I
I
C
C
C
E
E
E
Read the Operator’s Manual before operating the compressor.
7.
Rotation
- Check for correct rotation of all electric motors:
•
Use controller “JOG MODE” to bump compressor motor.
Proper rotation shall be counter-clockwise
when facing the compressor sheave.
•
Use controller “JOG MODE” to bump heat exchanger cooling fan.
Proper rotation is achieved when
cooling air is discharged upward through cooler core.
C
C
C
A
A
A
U
U
U
T
T
T
I
I
I
O
O
O
N
N
N
Summary of Contents for VS-11
