![background image](http://html1.mh-extra.com/html/gardner-denver/reavell-h5000-series/reavell-h5000-series_operators-handbook-manual_3870357033.webp)
COMMISSIONING OR RECOMMISSIONING
PAGE 31
7 COMMISSIONING OR RECOMMISSIONING
W A R N I N G :-
BEFORE OPERATING THIS EQUIPMENT USERS SHOULD BE MADE AWARE OF AND ENSURE
COMPLIANCE WITH THE HEALTH AND SAFETY REGULATIONS APPROPRIATE TO THIS CLASS OF
WORK. ATTENTION OF U.K. USERS IS DRAWN TO THE HEALTH AND SAFETY AT WORK ACT, 1974
& CONTROL OF SUBSTANCES HAZARDOUS TO HEALTH REGULATIONS 1988
TAMPERING WITH SAFETY VALVES IS DANGEROUS AND ALSO INVALIDATES THE GUARANTEE.
7.1 BEFORE STARTING
Ensure familiarity with safety devices and type of control.
NOTE: Low oil pressure and high air temperature switches are pre set and should not be adjusted.
Ensure suction filter is in good condition and filter element is fitted. Make sure that any protective blank
fitted to the first stage suction is removed. Check that silencer bore and any suction pipework is clean
before reassembling.
IMPORTANT: For first commissioning run or following overhaul or after compressor has stood idle for an
extended period, MINERAL oil of the recommended grade must be used for the first 50 to 100 hours
running time. After this synthetic oil of the correct grade should be used.
Check that the inside of the crankcase is clean and filled with the correct grade of lubricant until oil level
sight glass is three quarters full. Maintain oil level to the upper limit on the sight glass .
Important:- Do
not overfill.
Remove the plug from the outer end cover, immediately above the main lubrication pump and prime the
pump suction port with the recommended oil. Replace the plug.
Turn over the compressor at least one revolution by hand, to ensure freedom of movement.
Open drain valves or remove drain plugs from each stage.
NOTE: It is not necessary to remove any inhibition lubricant which may have been applied before
despatch, unless there are specific instructions attached to the compressor stating otherwise.
Summary of Contents for Reavell H5000 Series
