Gardner Denver RBS 15, Parts List Operating And Service Manual

Page: 27 / 42

RB-7-100 Page 26
SECTION 6
DISASSEMBLY AND ASSEMBLY INSTRUCTIONS
Disassembly the blower within the guarantee period results in the cancellation of the guarantee.
Disassembly, repair work and reassembling of the blower must be carried out only by qualified personnel and with
the aid of suitable equipment and relevant manual.
This manual provides both the assembly and disassembly operations necessary for ordinary maintenance.
For any references to components see the drawings at pages 29.
NOTICE
Warranty does not cover damages caused by operations carried out incorrectly during disassembly and/or
reassembling of the blower.
DISASSEMBLY
Before starting disassembly stop the blower by following the procedure described at paragraph 6
PREPARATION OF THE BLOWER
Disassemble the drive components (pulleys, coupling
) following manufacturer’s instructions if there are
locking devices or by means of an extractor if attached directly onto the shaft.
Do not hammer the shaft coupling or pulley
Dispose the used oil in accordance with local regulations
DISASSEMBLY OF DRIVE SIDE SUMP
Remove the key 30.
Fix the side cover 5A by four clamps at least.
Loose the fixing screws and extract the sump 12A and extract it.
Reassembling
Before reassembling, thoroughly clean all components and lubricate with oil those components, which have to
slide over each other
Reassembling of drive side sump
Lubricate the lip of the seal and sliding housing on the shaft with grease
Mount the sump 12A on the cover SA with a new gasket 50 in between.