13–10–612 Page 48
When assembling the element in the body, be sure the
wing nut is tight and the clamp on the filter holds the
cover firmly against the gasket.
Do not oil this element. Do not wash
in inflammable cleaning fluids. Do
not use solvents other than water. Im-
proper cleaning may damage the ele-
ment.
Never operate the unit without the ele-
ment. Never use elements that are
damaged, ruptured or wet. Never use
gaskets that won’t seal. Keep spare
elements and gaskets on hand to re-
duce downtime. Store elements in a
protected area free from damage, dirt
and moisture. Handle all parts with
care.
Use only genuine Gardner Denver air
filter elements on Gardner Denver
compressor units. Genuine parts are
available through your authorized
Gardner Denver distributor.
Filter Element Life – The element should be replaced
after six cleanings or if:
1.
Visual inspection indicated a rupture, crack, or pin
hole in the pleated media. Inspection should be
done by placing a bright light inside the element.
2.
Pressure drop through a filter with a freshly
cleaned element is below 3 inches of water with
compressor running at full load – this would indi-
cate a rupture or crack.
Inlet Screen and Tube – Inspect the inlet screen and
tube for dirt accumulation each time the filter element
is serviced. Clean the tube when required by ramming
a clean dry cloth through the tube. Wipe the inside of
the filter body to remove any dirt falling from the inlet
tube before reinstalling the element.
Causes of short element life include: severe dust
conditions, infrequent servicing, improper cleaning, or
contamination by oil or chemical fumes.
Summary of Contents for ELECTRA-SAVER EAU PD - 200 HP
