Cleaning the filament cassette
and area around the filament
cassette :
E
3
F
D
I
F
13
GB
Risk of injury !
Pulling the filament
out of the filament cassette :
6. Trouble-Shooting
Risk of injury from the cutting filament !
V
Always unplug the mains plug of the Turbotrimmer be-
fore troubleshooting.
You can pull the filament out of the filament cassette if the fila-
ment is too short or if it is drawn inside the cassette.
1. Unplug the mains plug.
2. Remove the filament cassette as described under 5. Mainte-
nance
“Replacing the filament cassette” .
3. Press together the plastic ring
E
on the filament cassette
D
between your thumb and forefinger.
4. Draw the plastic ring
E
with the thumb of the other hand over
the side part of the filament cassette
D
(use a screwdriver
if necessary).
You can now access the filament that was
drawn into the filament cassette.
5. Unwind the filament
3
approximately
10 cm and thread it through the eye
of the plastic ring
E
. If necessary,
loosen the filament beforehand using a
screwdriver. The filament
3
may stand out
max. 2 cm over the knife
H
.
6. Pull the plastic ring
E
back over the
filament cassette
D
.
7. Reinstall the filament cassette as described
under 5. Maintenance
“Replacing the filament cassette”.
If the automatic filament feed still does not work after pulling
the filament out of the filament cassette, the filament cassette
and area around the filament cassette may be dirty.
1. Remove the plastic ring
E
from the
filament cassette
D
as described
under
“Pulling the filament out of the
filament cassette”.
2. Unwind the filament
3
, clean the
filament cassette and the filament
then wind the filament back onto
the cassette.
3. Clean the automatic mechanism
lever
I
in the filament cassette
holder
F
.
The automatic mechanism lever must move freely.
4. Reinstall the filament cassette as described under
“Pulling
the filament out of the filament cassette”.
Only GARDENA Service Centres and authorised specialist
GARDENA dealers may carry out repairs.
H
D
E
3
E
