ITEM #05739 Rev B
15
Garaventa Genesis Hydraulic Drive
Preventive Maintenance Inspection
To Be Performed At Least Once Each Year
Name_________________________________________
Date: ______________________
Address: ______________________________________
Shaftway:
θ
Enclosure:
θ
______________________________________________
Serial No.: __________________
______________________________________________
Hours on Counter: _____________
Location:______________________________________________________________________
Mast Cables
θ
Check all bolts securing mast rails.
θ
Check the Travelling cable for wear.
θ
Check Oil Level. (If oil is very dirty,
θ
Check all cables are securely attached.
investigate cause and replace.)
θ
Check for leaks on unions, (tighten if loose.)
Platform
θ
Check all bolts securing Motor.
θ
Check for leaks on cylinder seal. Replace if
θ
Ensure the platform cannot be rocked
required.
excessively. Shim if necessary.
θ
Check 4 Carriage Wheels are secure.
θ
Check for evidence of rubbing the shaftway.
θ
Is the platform spongy? Bleed the air from the
If so, what corrective action is required to
cylinder. (See bulletin.)
correct.
θ
Is the chain and sprocket in good condition and
correctly tensioned. The attachment on the
_________________________________
carriage slack rope device must be level.
_________________________________
θ
Does the slack rope device work at rated load.
_________________________________
Contact the factory for full test schedule.
θ
Is the slack chain switch activated by the action
Control
of the mechanism.
θ
Does the self leveling device work at mid and
θ
Check all the control buttons for function.
upper landings. (Use the remote emergency
θ
Check the keyswitches.
lowering to assist test the function.)
θ
Confirm the motor amps and pressure.
Doors & Gates
Amps Pressure
θ
Load _____ ______
θ
Check the door and gate closers.
θ
No Load _____ ______
θ
Check the hinge bushings for wear or damage.
θ
Check the pressure relief valve in accordance
θ
Check the door/gate for interference with the
with the procedure laid out in the Genesis
frame.
Service
Manual.
θ
Check Mast Tieback Bracket Fasteners.
Battery & Lights
θ
Check Track/Rollers for dirt, damage & cracks
θ
Is the battery charged.
θ
Do the platform lights work.
Safety Device
(Replace light bulbs as necessary.)
θ
Check the interlocks for function.
Clean
Up
θ
Check the service key.
θ
Check the limit switches for platform
θ
Remove spilled oil inside mast.
stopping
position.
θ
Clean out any dirt and dust from the shaft base
θ
Check the final limit switch.
area.
θ
Check the alarm.
θ
Check for water in the shaftway pit.
Clean up any marks or fingerprints on panels.
θ
Clear the pit drain, if fitted.
Note any signs of corrosion, take photos and report to Garaventa (Canada) Ltd. Refer to your Genesis
Service Manual for further information.
