94
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
4.4 Function “ Height ”
4.4.1 Definition
For height changes, the function allows changing either front, rear, or all corners simultaneously. These
changes will also affect the other modes as the standard height is the reference point. For example, if
the standard mode is lowered by 10 mm, access mode, motorway, and off-road heights will also be 10
mm lower.
On
L322-02,
the off-road, motorway and access modes can also be changed.
WARNING
The IIDTool allows changing of vehicle settings to a state out-
side of the original manufacturer specification.
It is the sole
responsibility of the user
to choose secure settings for the
applicable use of the vehicle.
Notes :
•
If values for the standard height are set too low (
L322-02
without raising the values for access
and motorway heights) the vehicle may reach the bump stops in access mode:
-
All except L322-02
In this case the EAS ECU registers a bottomed out condition and enters
‘Extended Mode’ automatically raising the vehicle (to allow the vehicle to drive out of the bot-
tomed out condition).
-
L322-02
If the height indicator light continues blinking after the vehicle was switched off, this
can cause a battery drain.
•
The height values are given in millimetres. This does NOT correspond exactly to changes in
height at the wheel. Measure all values to be sure.
• If the values for the standard height are set too high (and/or Off-Road height on a
L322-02
) the
suspension can reach a fully extended condition in off-road mode. In this condition, there is no
upward suspension travel.
There is a severe risk of damaging components and the vehicle
can become uncontrollable in this state!
GAP Diagnostics assumes no liability for damages
or injuries incurred during use or resulting from the use of the IIDTool.
•
Changes in height are instantaneous in the EAS ECU but the ECU won’t apply these changes
immediately. The EAS ECU will adjust a corner when it’s +/- 10 mm or higher than the desired
height. For example, if the corner is at +9 mm, it will not adjust the height.
Summary of Contents for IIDTool Pro
Page 190: ...190 IIDTool Appendix...
