104
105
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
Preparations
• Turn engine OFF
• Select neutral, depress and hold brake pedal
• Start the routine and follow instructions on screen
Usages
This function is used when:
• The sensor is replaced
• The transfer box ECU is replaced or re-flashed
4.6.6 Engine
(L316-12 with DSC)
Steering angle sensor calibration
This routine will calibrate the steering angle sensor centre position.
Preparations
• Place the vehicle on a flat and level surface.
• Ensure that your front wheels and steering wheel are straight before proceeding.
Usages
This function is used when:
• The steering angle sensor is replaced.
• A wheel alignment is performed on the vehicle.
• It may be required if parts of the steering system have been replaced or removed.
4.6.7 Active Damping (L322-10)
Needed when the active damping ECU is replaced or updated.
4.6.8 Suspension
For baseline calibration, the standard function allows changes to each corner individually, Front Left,
Front Right, Rear Left and Rear Right.
This is only required when height sensors, linkages or any parts related to height measuring
are replaced or reinstalled. It may also be needed after a wheel alignment. For height changes,
raising or lowering the vehicle, please refer to the Height function
).
Summary of Contents for IIDTool Pro
Page 190: ...190 IIDTool Appendix...
