This device is equipped with an external control signal terminal for remote operation.
Connection
㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃 㻃
Refer following figure for connector wiring.
Pin No.
Description
1
A (+)
2
B (-)
3
GND
4
A (+)
5
B (-)
6
GND
7
DAY&NIGHT
external control terminal
Connect the supplied cable to the connector when this terminal is used and use a shielded
twisted pair cable as an extension cable. Use adequate insulation coating to avoid short
circuiting the connection area.
Figure 17
Note)
Disconnect the power for connection.
Use the same terminating resistance value for impedance of the cable used. (100
Ω
)
External Control Signal Terminal
En-22
Figure 16
Enlarged
figure
