![background image](http://html1.mh-extra.com/html/gantner/gt7-2x00/gt7-2x00_installation-configuration-manual_3426326018.webp)
GT7 Terminal
Installation
18
HB_GT7-2x00-3x00--EN_12
www.gantner.com
3.3
Installing the Rear Part
If the GT7 terminal is being installed in an outdoor area or another location that is not protected against dripping
water, the wall gasket (2) must be used (see Figure 3.1). Proceed with the following steps:
► Remove the protective foil from the back of the wall gasket.
► Attach the wall gasket onto the back of the rear part as shown in Figure 3.1. Ensure that the gasket sits flat
between the domes of the housing.
1
GT7 rear part
2
Wall gasket
Figure 3.1
– Attaching the wall gasket (measurements in mm)
► To mount the rear part, drill the appropriate mounting holes in the wall or desktop. The following 3 installation
options are available:
1. Surface mounting without flush-mounted box (3 holes)
Figure 3.2 - Surface mounting without flush-mounted box (measurements in mm)