Gamry Interface 5000, Operator'S Manual

Page: 77 / 86

Appendix F: Heat in Interface 5000 Multichannel Systems--Introduction to Device Power-dissipation
77
Appendix F: Heat in Interface 5000 Multichannel Systems
Introduction to Device Power-dissipation
All electronic devices require power to operate. In most cases, this power generates heat within the device. The
simplest model for device power assumes the device can be modeled as a simple resistor across the power
supply inputs. This simple, but often useful, model ignores the details of internal power supplies within the
device, active circuitry, and power in I/O circuitry.
The power dissipated in a resistor is given by:
R
V
R I I V P
2
2    
P is power in watts, V is voltage in volts, I is current in amperes, and R is the resistance in ohms.
In this simple model, a device powered from +48 V with a power supply current of 0.1 A dissipates the same
power as a 480

resistor, that is, 4.8 W.
Normally the power- supply voltage is assumed to be constant, so a device’s power depends on the current
requirements which vary with the device ’ s operating conditions.
Figure E-1
Interface 5000 Simplified Power Model Full Rail Voltages
Potentiostat/Galvanostat Power Model
A potentiostat requires a somewhat more sophisticated power-dissipation model. A simple potentiostat power
model is shown above.
The electrochemical cell has a voltage Vcell that plays a role in the instrument’s power
dissipation.