36
EN
Recall Function
This function is used to recover the power levels, timer settings and rapid heating after the hob has
been switched off inadvertently.
If the hob is switched off and on again within 6 seconds, all the previous settings (power levels,
timer, rapid heating) will be recovered automatically.
The recall function cannot be deactivated by the user.
Activation:
The hob has been switched off.
Turn the hob on again using ON/OFF (1).
The Pause key || (10) flashes for 6 seconds.
Touch the Pause || key (10).
The recall function becomes active (an acoustic “beep” is emitted). All the previously set power
levels, timers and rapid heating are restored.
Autonomous Timer Function
The independent Timer function is a countdown independent of the cooking zones and extraction
which emits an acoustic signal (beep) when it expires.
The Timer is activated by pressing the central key (5) between the two + / - keys (6).
When the Display shows “–--" then the Timer can be set.
Set the desired duration of the timer using the + / - keys (6) and it will be shown on the display (5).
The timer starts 10 seconds after activating this function (by not pressing any other command).
The format of the autonomous Timer is
The timer can be set up to a maximum of 600 minutes.
The remaining time will be displayed in the Zone/Display (5); at the end of the countdown an
acoustic signal (beep) will be emitted.
If the remaining time of the timer is less than 1 minute, it will be displayed in the format shown
below and the dot will have a steady light:
-> minutes
-> seconds
To turn off the Timer, proceed in two ways:
-> select (5) and set the duration of the Timer to
, using + / - (6)
or
-> press the ON/OFF key (1) twice
