© Copyright
Gallo Technologies
. All Right Reserved
- 9 -
061515V54RS
B. Function Programming:
1. System must be in Disarm mode (green “Start/Stop Engine” button LED flashing).
2. Press valet switch 5 times, hold on the 5
th
press for over 5 seconds, parking lights will flash 2 times.
3. According to the “Function Option Chart” below, you can set up the required function by pressing the Valet
Switch the number of times indicated in Table 1 page 9.
4. Immediately after pressing the valet switch the number of time indicated, press the
button on the key FOB. If
the parking lights flash 3 times, the default setting for that function has been set. If the parking lights flash 1 time,
the alternate setting has been set.
Note: After entering the “Function Programming” mode, the
button must be pressed on the key FOB within 5
seconds. If not, the system will exit the “Function Programming” mode and the parking lights will flash 4 times.
Repeat steps 1 thru 4 for each additional programming function.
Table 1: FUNCTION OPTION CHART
Press Valet
Switch # of
Times
Programmable
Function
Function Default
Lights flash 3 times
Function Alternate
Lights flash 1 time
1
Remote start
Enable
Disable
2
Remote start run time
10 min
15 min
3
Gasoline/Diesel Engine
Gasoline Engine
Diesel Engine
4
Ignition 2 output
Enable/Disable during
Engine start
Ignition 2 OFF during
Engine Start
Ignition 2 ON during
Engine Start
5
Silent arm/Disarm
ON
OFF
6
Foot-Brake Door
lock/unlock
ON
OFF
7
Auto Rearm
OFF
ON
8
Auxiliary output time
2 sec duration
15 sec duration
9
Aux output door unlock
Unlock Doors
Do not Unlock Doors
10
Electric siren/horn
Siren
Horn
11
Central Door lock Time
(for 1 Pulse only)
0.8sec.
4sec
12
Door unlock Pulses
1 Pulses
2 Pulses(0.8sec*2)
13
Voltage/Tach Engine
running detection
Alternator(Voltage)
Tach sensor
14
Return all to factory
default
