-
-
-12-
-12-
4.2.- FITTING OF CONTROL INSTRUMENTS AND SERVOLUBRICATOR
4.2.- FITTING OF CONTROL INSTRUMENTS AND SERVOLUBRICATOR
Connect control instruments as per
Connect control instruments as per installation scheme. Fit the push-button valve
installation scheme. Fit the push-button valve
““ V”
V”
at a maximum distance o
at a maximum distance o
5 metre from the
5 metre from the starter and use flexible pipe of
starter and use flexible pipe of 2.5 mm inner diameter for connection. If the
2.5 mm inner diameter for connection. If the control pipe has to
control pipe has to
be longer, fit a
be longer, fit a solenoid valve near the starter and connect same with an electrical remote control valve.
solenoid valve near the starter and connect same with an electrical remote control valve. In this
In this
case it is
case it is recommend
recommended using a starter equipped with a
ed using a starter equipped with a GALI starting limiter.
GALI starting limiter.
In installation comprising automatic starting and engine control equipment, the push-button valve
In installation comprising automatic starting and engine control equipment, the push-button valve
““ V”
V”
can be
can be
replace by a solenoid valve.
replace by a solenoid valve.
Fit the
Fit the servolubricato
servolubricatorr
““ S”
S”
vertically in
vertically in a well visible and practicable place to
a well visible and practicable place to allow for easy priming, control and
allow for easy priming, control and
refilling.
refilling.
4.3. - SUPPLY OF COMPRESSED AIR
4.3. - SUPPLY OF COMPRESSED AIR
The starter is designed to deliver its
The starter is designed to deliver its maximum torque at 30 bar, although this pressure will not
maximum torque at 30 bar, although this pressure will not always be
always be
necessary to carry out start-up.
necessary to carry out start-up. The minimum pressure necessary to achieve motor start-up will depend on each
The minimum pressure necessary to achieve motor start-up will depend on each
specific application. GALI guarantee
specific application. GALI guarantees that all
s that all A45 starters carry out
A45 starters carry out the meshing movemen
the meshing movement and main valve
t and main valve
opening at least up to 8 bar.
opening at least up to 8 bar.
In no case should the
In no case should the starter be subjected to pressures greater than 30 bar.
starter be subjected to pressures greater than 30 bar.
