-
-
-14-
-14-
5.- FIRST START UP
5.- FIRST START UP
5.1. - AIR FEEDING CIRCUIT
5.1. - AIR FEEDING CIRCUIT
The tube should be cleaned with pressurised air before being coupled to the starter, t
The tube should be cleaned with pressurised air before being coupled to the starter, taking
aking
particular care to prevent loose particles reaching the interior, due to
particular care to prevent loose particles reaching the interior, due to welding the pipes or for
welding the pipes or for
any other reason.
any other reason.
5.2. - CHECKING ASSEMBLY
5.2. - CHECKING ASSEMBLY
Ca
Carry out all t
rry out all t he installation checks without
he installation checks without pressure in the line.
pressure in the line.
Check that the installation has been carried out in accordance with
Check that the installation has been carried out in accordance with the general instructions provided above
the general instructions provided above. In
. In
particular, verify that the line
particular, verify that the line has no passing restrictions, with regard to that indicated in
has no passing restrictions, with regard to that indicated in point 4.3.
point 4.3.
Test for leaks and check that the control circuit is not choked.
Test for leaks and check that the control circuit is not choked.
Check that the air
Check that the air receiver is charged and that the flow
receiver is charged and that the flow valve is opened
valve is opened
5.3. – PUTTING INTO SERVICE
5.3. – PUTTING INTO SERVICE
AL
AL
WAYS RESPECT THE SAFETY INSTRUCTIONS
WAYS RESPECT THE SAFETY INSTRUCTIONS
OF THIS MANUAL
OF THIS MANUAL
Before conne
Before connecting
cting the starter to an installation that is
the starter to an installation that is in service, the air should always
in service, the air should always
be discharged from it.
be discharged from it.
When the installation is completed, open the air feed valve carefully, observing if
When the installation is completed, open the air feed valve carefully, observing if there is any leak; in
there is any leak; in such a
such a
case, close it again, empty the
case, close it again, empty the pipe slowly and clear the problem.
pipe slowly and clear the problem.
Check the adjustment of the auto-start device (if
Check the adjustment of the auto-start device (if installed), to ensure:
installed), to ensure:
-the speed of the starter shaft never exceeds the value of 2500 r/min for type A45
-the speed of the starter shaft never exceeds the value of 2500 r/min for type A45
-the starter stops working, once
-the starter stops working, once the engine has attained a speed 1 to 1.5
the engine has attained a speed 1 to 1.5 times its ignition
times its ignition
speed.
speed.
Check for correct meshing of t
Check for correct meshing of the driving pinion with the flywheel gear ring
he driving pinion with the flywheel gear ring by jeans of several
by jeans of several
short starter impulses.
short starter impulses.
