-
-
-27-
-27-
11.5. - FRONT SECURING FLANGE
11.5. - FRONT SECURING FLANGE
As well as
As well as a great number of standardized flanges, GALI can deliver specific front
a great number of standardized flanges, GALI can deliver specific front securing flanges for any
securing flanges for any
application of its starters.
application of its starters.
11.6. – SERVOLUBRICATOR SL6
11.6. – SERVOLUBRICATOR SL6
This servolubricator has been especially designe
This servolubricator has been especially designed to be
d to be used with the GALI air
used with the GALI air starters. Yet it
starters. Yet it may also be
may also be
employed for the lubrication of
employed for the lubrication of any kind of
any kind of pneumatic circuit operating intermittently.
pneumatic circuit operating intermittently.
Upon reception of a pneumatic signal, the pump of the
Upon reception of a pneumatic signal, the pump of the servolubricator injects a certain quantity of oil into
servolubricator injects a certain quantity of oil into the
the
correspondin
corresponding inlet, which is
g inlet, which is normally the feed air inlet of
normally the feed air inlet of the equipment to be lubricated.
the equipment to be lubricated.
The oil reservoir; not being pressurized, can be
The oil reservoir; not being pressurized, can be refilled without isolating from the air main.
refilled without isolating from the air main.
When actuating the servolubricator several times, the pump will be primed automatically. To ensure the oil
When actuating the servolubricator several times, the pump will be primed automatically. To ensure the oil
enters the starter motor from
enters the starter motor from its first operation, we recommend performing 4-5 feint starts at
its first operation, we recommend performing 4-5 feint starts at maximum injection
maximum injection
volume allowing the lube-pip
volume allowing the lube-pipe to fill-up. Thereafter, the
e to fill-up. Thereafter, the injection volume has to be adjusted again to the desired
injection volume has to be adjusted again to the desired
volume.
volume.
The necessary oil quantity depends upon the starting frequency and duration and on the condition of the feed
The necessary oil quantity depends upon the starting frequency and duration and on the condition of the feed
air (degree of humidity, salinity and pollution). For a
air (degree of humidity, salinity and pollution). For a starting duration of 0,5 to
starting duration of 0,5 to 2 seconds, we would advise:
2 seconds, we would advise:
-Type A15 starter: 0,4 cm
-Type A15 starter: 0,4 cm
3
3
In case of infrequently used starting equipment or unfavourable starting conditions, the lubrication has to be
In case of infrequently used starting equipment or unfavourable starting conditions, the lubrication has to be
intensified, however.
intensified, however.
The sevolubricator may be installed in
The sevolubricator may be installed in any desired position, although we recommend its installation in
any desired position, although we recommend its installation in a higher
a higher
place than the starter and possibly near to
place than the starter and possibly near to same.
same.
Adjustment:
Adjustment:
This servolubricator has an adjusting screw and an external indicator showing the oil volume injected for each
This servolubricator has an adjusting screw and an external indicator showing the oil volume injected for each
operating cycle. When turning the adjusting screw to the right,
operating cycle. When turning the adjusting screw to the right, the infection volume will be increased, and when
the infection volume will be increased, and when
turning it to the
turning it to the left, the volume will be
left, the volume will be reduced.
reduced.
* Measurements in mm
* Measurements in mm
