Galaxy GHDX2-2430S-16F4D Installation and Hardware Reference Manual
2-4
General Installation Procedure
Step 3.
Install hard drives:
Although hard drives have been pre installed
into trays, a drive may need to be replaced. Follow the
installation procedures to install a drive in a drive tray. (See
Section 2.8
)
Step 4.
Install drive trays:
After the hard drives have been installed into
the drive trays, the drive trays must be installed into the enclosure
itself. (See
Section 2.9
)
Step 5.
Cable connection:
Use the power cords that came with the
subsystem to connect the subsystem to the main power source.
Use the self-purchased Fibre cable to connect a host port to the
host computer or an external device.
Step 6.
Power up:
Once the components have been properly installed and
all cables are properly connected, you can power up the
subsystem and configure the RAID array. (See
Section 4.4
)
2.4.1 Installation Procedure Flowchart
Figure 2-1
shows a flowchart of the installation procedure. As you complete
each step, check off the “
Done
” box on the right. Please use this flowchart
in conjunction with the instructions that follow.
Figure 2-1: Upgrade Procedure Flowchart
