GAL MOVFE 2500, Electrical Manual

Page: 68 / 92

62
CLUTCHENGAGEDDISTANCESETUP
To set the Clutch Engaged Distance (CED), flip the 1
st
switch to SETUP. Press the
key. Physically move the door to the fully closed position. Record the count as Count1.
Move the door in the Open direction until the mechanical clutch is fully engaged and the
zone lock device is fully cleared. Record the count as Count2. Subtract Count1 from
Count2. Set Par. 76 =1. Enter the difference, Count2 minus Count1, of the Count into
Par. 83. Set Par. 76 = 0 so that Par. 83 can be displayed in percentage, instead of
pulses. The clutch engaged distance setup will help smooth the open cycle and prevent
fuses from blowing.
VOLT
PULSE
CLUTCH REAR VANE BY 1/8" PAST
1/2" APPROX.
BUMPER
BUMPER
REMOVED
CAR DOORS 1/2" OPEN
HATCH DOOR
DOOR IS FULLY CLOSED AND CAR DOORS
THE ROLLER, AS SHOWN, WHEN HATCH
IS 1/2" FROM STRIKING POST.
1/8"
CAR DOOR
HATCH DOOR
ON THE ROLLER.
THE CLUTCH REAR VANE IS 1/2"
WITH DOORS FULLY ENGAGED
CAR DOOR
1/2"
RECORD AS COUNT 2
(COUNT 2 - COUNT 1 ) PAR. 83
DCL
RECORD AS COUNT 1
SIDE OPENING DOOR
CAR DOOR
HATCH DOOR
CAR DOORS 1" OPEN
1/8"
DOOR IS FULLY CLOSED AND CAR DOORS
THE ROLLER, AS SHOWN, WHEN HATCH
IS 1/2" FROM STRIKING POST.
CLUTCH REAR VANE BY 1/8" PAST
CAR DOOR
DOORS FULLY ENGAGED
HATCH DOOR
1/2"
THE CLUTCH REAR VANE IS 1/2"
WITH DOORS FULLY ENGAGED
ON THE ROLLER.
1" APPROX.
RECORD AS COUNT 2
CENTER PARTING DOOR
RECORD AS COUNT 1
(COUNT 2 - COUNT 1 )
PAR. 83
DCL
DOORS FULLY ENGAGED
62