Talano & Alera User Manual
v1.4
7
If the bath has the Autofill option, the bathing cycle can be
completed without having to worry about overfilling. Simply
press a button and the bath will fill automatically.
Filling the Bath
The autofill has two buttons for operation and one spout, the
red button for hot water and the blue button for cold.
Press the red or blue fill button situated on the rim of the
bath.
Fig 1.
The autofill buttons will glow on standby, and
flash during filling.
This will fill the bath to a pre-set fill level.
Fig 2.
Once the pre-set fill level is reached the water will
automatically stop. If at any time you wish to stop the autofill
process simply re-press the button.
The system allows you one additional top up past the pre-
set fill level. Press the red or blue fill button; this will deliver
water for a maximum of 30 seconds. Once again the flow
can be stopped by re-pressing the button.
Temperature Adjustment
The red fill button supplies hot water at a pre-set
temperature (usually 43
°
C). To reduce the temperature of
the bath water during the autofill process, press the blue
(cold) button.
Fig 1.
When the bath filling is complete check the water
temperature before the bather enters, or for ‘walk-in baths’
the user can stop, start or modify flow temperature as
required throughout the autofill process.
Note
– Once the maximum fill level has been reached, water
must be drained before any more water can be added.
Fig
2.
If you are unable to top up, drain water to below the pre-
set fill level.
Tamperproof Lock Out - Fig 3.
The autofill has a lock out to prevent wastage of water and
tampering.
To Lock
Press and hold down both hot and cold buttons for 10
seconds. The red and blue LED lights will go out, confirming
water lock out.
To Unlock
Press and hold down both buttons again for 10 seconds.
The buttons will turn red and blue confirming unlock.
For optimum performance it is recommended that the bath is
cleaned regularly.
AUTOFILL OPTION
Fig 1
Fig 2
Fig 3
