Talano & Alera User Manual
v1.4
4
The Handset locates on the handset holder on the side of the bath.
When not in use please ensure that it is replaced to avoid damage.
The Handset consists of two control buttons: ‘Seat out’ and ‘Seat in’.
To avoid damage to the handset the control buttons should only be
pressed lightly. The handset is safe to use with wet hands but
should not be immersed in water.
An illuminated light shows that the bath is correctly powered up.
Check that the bath water is an acceptable temperature before
commencing the bathing cycle.
Step 1
– Place the seat into the starting position outside of the
bath
Press the “Seat out” button.
This will raise the seat out of the bath and bring it to its lowered
starting position ready for the bather.
The seat may be stopped at
any time by releasing the ‘Seat out’ button.
Step 2
– Place the bather onto the seat (Fig 1)
Ensure that the lap strap has been fitted and seat arms are placed
into the lowered position.
Step 3
– Lift the bather into the bath (Fig 2 & Fig 3)
Press the “Seat in” button
This will raise the seat. Once it has reached its maximum height it
will rotate until the bather is positioned directly above the water. The
seat will then lower the bather into the bath, before finally coming to
rest once the bather is immersed in water .
The seat may be
stopped at any time by releasing the ‘Seat in’ button.
Step 4
– Lift the bather out of the bath (Fig 4)
Press the “Seat out” button.
This will raise the seat out of the bath. Once it has reached its
maximum height it will complete a quarter turn so that the bather is
positioned as shown in figure 2. The bath will then lower the bather
until it reaches the ‘starting position’ outside of the bath. The bather
can then exit the seat.
The seat may be stopped at any time by
releasing the ‘’Seat out button.
HANDSET INSTRUCTIONS
