Gaggenau VL414115, User Manual And Installation Instructiions

Page: 7 / 32

Accessories
en
7
6 Accessories
Use original accessories. These have been made espe-
cially for your appliance.
Accessories Order number
Ventilation moulding for
operation beside a
VG415/425 gas appli-
ance AA414010
7 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
7.1 Colour shades of the illuminated rings
The illuminated ring on the control knob lights up or-
ange during operation. You can choose between two
colour shades.
If you have several appliances installed next to each
other, you can change the shades in the basic settings
for the appliances so that all of the illuminated rings
light up in the same shade.
→
"Basic settings", Page 15
7.2 Setting regenerable odour filters
Note:
The regenerable odour filter is available as a
special accessory for air recirculation.
Requirements
¡
Your appliance is equipped with a regenerative
odour filter.
¡
Your appliance is connected to the Home Connect
app.
→
"Home Connect ", Page 8
▶
Set the filter type in the Home Connect app.
8 Basic operation
8.1 Switching on the appliance
▶
Push in the control knob and turn it clockwise to the
fan setting you require.
a
The illuminated ring on the control knob lights up or-
ange.
8.2 Switching off the appliance
▶
Turn the control knob anti-clockwise to ​⁠.
If the fan run-on is activated, the appliance contin-
ues to run for a short time after it is switched off.
→
"Fan run-on", Page 8
8.3 Sensor control
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡
Factory setting: 2
¡
Lowest setting: 1
¡
Highest setting: 4
You can change the sensitivity of the sensor in the
Home Connect app.
Switching on automatic mode
The optimum fan setting is set automatically using a
sensor.
▶
Push in the control knob and turn it clockwise to ​⁠.
a Automatic mode is activated.
a
Using the sensor, the appliance automatically
switches on the optimum fan setting 1, 2, 3 or the
intensive mode.
a The illuminated ring on the control knob will be lit
orange while the ventilation system is switched on.
Switching off automatic mode
Note:
If the sensor no longer detects odours, the appli-
ance selects the lowest fan setting. The appliance
switches off the ventilation system after 20 minutes in
air recirculation mode and after 6 minutes in air extrac-
tion mode.
▶
Turn the control knob anti-clockwise to ​⁠.