Gaggenau RX496, Installation Instructions Manual, Page: 24 / 26

24
10. R emov i ng the ant i t i p stab ili se r
The antitip stabiliser must not be removed until the
appliance is firmly screwed into its installation location
and thereby secured against tipping over.
1. Loosen both nuts.
2. Pull the antitip stabiliser out of the threaded bolts.
3. Slot the antitip stabiliser’s rear mounting point onto
the threaded bolt at the front. The castor must be on
the lefthand side.
4. Tighten both nuts.
11. F i tt i ng the base pane l
Adjust i ng the depth of the base pane l
1. Unscrew the nuts from the angle brackets and
remove the spacer washers.
The angle brackets have 5 holes for adjusting depth.
2. Reposition the angle brackets.
3. Refit the nuts and washers and tighten.
F i tt i ng the base pane l
1. Push the base panel into the quick clips.
2. Check the position of the base panel and readjust
the depth of the base panel if necessary.
The base panel may not contact appliance parts,
because this might generate undesired noises.