20
8.
F
i
tt
i
ng the k
i
tchen un
i
t doo
r
s
The door handles must be fitted before the kitchen unit
doors are fitted.
1.
Place the drilling templates against the back of the
kitchen unit doors and align at the edges.
a
Kitchen unit doors with oversize:
Alignment point for the top edge of the template:
Top edge of furniture door plus oversize
a
.
2.
Affix the drilling templates using adhesive tape.
3.
Drill pilot holes (drill diameter 1 mm).
Do not drill too deep.
4.
Remove the drilling templates.
5.
Pull out the door cover upwards.
6.
Unscrew the nuts.
7.
Remove the fixing rail.
8.
Secure the fixing rail to the furniture door using four
screws.
The screws must not be too long.
9.
On the cooling compartment door, drill through the
existing 4 holes, holding the seal to the side in the
process (drill diameter 4.5mm).
Take care not to damage the seal.
10.
On the outside of the cooling compartment door,
affix spacers to the drilled holes.
The spacers prevent the furniture door from
deforming.
Summary of Contents for RX496
Page 1: ...Gaggenau en Installation instructions RX 496...
Page 2: ......
