![background image](http://html1.mh-extra.com/html/gage-bilt/gb743shavt/gb743shavt_instructions-manual_4322568011.webp)
11
REV 3/23
GB743SHAVT
FILLING AND BLEEDING PROCEDURE
Images may not reflect actual tool
1.
Disconnect air supply from the powerunit.
2.
Fill oil reservoir approximately 3/4 full on booster. Use hydraulic oil (AW
-
32 or equivalent).
3.
Carefully remove button head cap screw (402482) and stat
-
o
-
seal (S572) from right hole on side of head cylinder assembly (743115).
4.
Provide a suitable container to bleed oil into.
5.
Reduce air pressure to 40 psi. (2.76 bar) during bleeding procedure. Connect air supply to powerunit.
6.
Point the bleed port towards a container, push actuator lever down and hold. (Block bleed port using a small piece of rubber material
before releasing actuator lever to prevent ingestion of air into powerunit).
7
Repeat until clear oil streams from port. Check reservoir after each cycle and refill when required. Do NOT drain reservoir below minimum.
8.
On last cycle of oil, hold lever (704345) down. Install button head cap screw (402482) and stat
-
o
-
seal (S572) prior to releasing the
lever (704345) and torque to 35
-
40 inch lbs. (3.95
-
4.52 Nm). Do not over tighten.
9.
Check stroke of
.900” (22.86
mm) using instructions a thru c and diagrams below. We recommend using dial calipers.
a. With the lever (704345) released check dimension (A).
b. Holding lever (704345) in, check dimension (B).
c. Subtract dimension (B) from dimension (A). If stroke is not consistent within 1/64" (.396 mm) repeat steps 1
-
9 until stroke met.
For your consideration, Gage Bilt offers a depth gage (Pt.# A
-
1935) to help simplify and more accurately check your tool stroke.
Please contact Gage Bilt for more information.
WARNING:
Use CAUTION when removing screws. Hydraulic oil may be under pressure.
CAUTION:
When bleeding tool, ensure tubing is free from kinks or other obstructions.
Fill oil reservoir approx. 3/4 full
GB808V BOOSTER
HANDLE/TOOL
Bleed port