GAELCO - TOKYOCOP
38
If the movement system is not working properly, the position potentiometers (TOK-305)
should be checked and changed if necessary. The following points need to be borne in
mind in this connection:
1. In Test Mode, go to the MOTION SYSTEM screen.
2. When the shaft lever is completely upright, the woodruff key will also be in the upright
position. Reach this position using the Left motor / Right motor options (see section 6.3),
then read the the “Pot” information for each motor. It should be 60 for both motors,
approximately.
3. Viewing the motors from above, when the shafts are in the position indicated, check that
the grub screw of the eleastic couplings are in the same position as shown in the
drawing. The left elastic coupling has the grub screws mounted in opposite, while the
right coupling has the grub screws aligned.
9.5
POSITION POTENTIOMETERS
Summary of Contents for TOKYOCOP
