7
Governors America Corp. © 2021 Copyright All Rights Reserved
EEG7500 Enhanced Electric Governor 8-2021-A8 PIB5115
The auxiliary (AUX) terminal accepts input signals from load sharing units, auto
synchronizers, and other governor system accessories. The AUX input enables or
disables the load sync input. GAC accessories connect directly to this terminal.
The AUX function decreases engine speed in response to increased input voltage.
Use the Auxiliary Polarity shift function to choose to increase engine speed as
input voltage increases:
•
To decrease speed set above 5 V DC.
•
To Increase speed set below 5 V DC. The AUX input is a 0 - 10 V DC reverse
polarity signal used to parallel to the mains, or load share multiple generators.
The AUX input also enables or disables the load sync input.
To use the AUX input at AI4, using the GAConfig Tool select
Configuration
Aux / Load Sharing
Auxiliary Enable checkbox.
Select the desired Auxiliary Polarity (Decreasing Speed or Increasing Speed) from
the drop down box. Polarity must be matched for all auxiliary products used with
the EEG7500.
auxiliary Input - analog Input 2: connector 2 - Terminal 8
Terminal 9, Analog Input 3, provides dedicated 4 - 20 mA input signal.
Terminal 10, Analog Input 4, provides dedicated 0 - 5 V DC input signal, or 4 - 20 mA with external 200 Ω resistor.
•
Terminal 11 pr5 V DC excitation, power to potentiometers or other equipment requiring power.
•
Terminal 6 is ground.
•
Terminal 7 provides Analog Input. Terminal 7 input must be equated to the GAConfig Tool
Physical
Input Mapping
Variable Speed Input Analog Input setting
Section 8 offers details on
using the potentiometer with the EEG7500
. For information on available
potentiometers see the
list on the GAC website.
Potentiometer Terminal
eeG7500 Terminal
Location
1
11
+5 V (power)
2
7
Analog Input
3
6
Ground
The potentiometers outer legs are used for power and ground while the middle is used for analog input. This
means that the value coming out of the third leg will change depending on how far the knob is turned.
+5 volt Power Supply: connector 2 - Terminals 6, 7, and 11
4 - 20 ma Input and 0 - 5 v Dc Input: connector 2 - Terminals 9 and 10
6
EEG7500
WIRING DETAIlS (CONTINUED)
