Elnur
powered by Gabarrón | INGENIUM WIFI Thermal Radiators | Installation Guide
10
7. CLEANING AND MAINTENANCE
The radiators do not need any special maintenance.
Clean dust with a dry, soft cloth only when the unit is
disconnected and cold.
Do not use solvents or abrasive products for cleaning.
After the heating season disconnect the radiator with
the switch located on the back surface of the radiator.
This thermal radiator has been manufactured under
an assured quality system using environment friendly
processes.
Please take the heaters to a clean point once their
useful life is finished, in order to recycle their materials in
the right way.
8. TROUBLESHOOTING
The radiator does not heat
Check the heater or the air inlets are not covered.
The room does not reach
the required temperature
Check the selected temperature is in accordance with the desired temperature.
Maybe the room needs more heating power.
“OC”, “SC” message is
displayed
Sensor wrong connection. Contact the after sales service.
“Err1”, “Err2”, “Err3”, “Err4”
message is displayed
Contact the after sales service.
Time settings are lost
There was electric supply shortage or the unit has been disconnected by the
main switch.
Keyboard does
not respond
If the Lock message is displayed, the thermal radiator keyboard is locked. Hold “+”
and “-” buttons simultaneously for 3 seconds to unlock the keyboard.
The radiator does not
communicate with the
G Control Hub
Check the unit is associated, the symbol must be shown on the display LCD.
For distances greater than 30 metros and 2-3 walls, associate first the closest unit
because of each unit can work as repeater.
If symbol is blinking, check the G Control Hub connection to the network, and if any
other device in the RF Net that could be working as repeater has been removed.
6. DEFAULT VALUES
Operation mode
OFF
Comfort temperature
19ºC
Economic temperature
17ºC
Frost protection temperature
5ºC
Ambient sensor Offset
0ºC
RF associated
No
Temperature Unit
ºC
Open Window detection
Disabled
Adaptive Start Control
Disabled
Control mode
PID
Default Programming in AUTO Mode
Comfort: 07:00 to 22:00.
Eco: 00:00 to 07:00 & 22:00 to 00:00.
