- 6 -
1. IMPORTANT
Please read these instructions before installing or using this appliance for the first time.
•
The warranty of the boiler will not cover any damage caused by non observance of any of these instructions.
•
This Guide must be kept and given to any new owner.
•
The use of these boilers is forbidden in any area where there is a presence of gases, explosives or inflammable objects.
•
Do not cover this boiler at any time.
•
It is essential that at no time are the air outlets covered.
•
Check that the voltage shown on the rating plate on the boiler is the same as the voltage of the supply to which
connection is to be made.
•
This boiler must be connected to the supply by fixed wiring. The supply circuit to the boiler must incorporate an isolating
switch having a contact separation of at least 3 mm.
•
The appliance must be installed in such a way that switches and other control devices cannot be touched by a person
using a bath or shower.
•
The installation must be carried out in accordance with the current electrical regulations. Any installation should be
carried out by trained personnel.
•
This boiler must be earthed.
•
Do not forget to disconnect the boiler from the supply before carrying out any work inside the boiler.
•
To maintain stability, it is essential that the boiler is placed on a level surface and care should be taken to avoid irregular
surfaces, such as may result from carpets or tiled surrounds partially protruding under the boiler.
•
The hydraulic connections should be done respecting the “output” “input” marking on the b
.
•
It is required a filling valve to be installed close to the boiler.
•
A drain valve should be installed at the lowest point of the installation.
•
The radiators need purging at the highest points of the installation.
•
It is important the pressure relief valve is allowed to drain into the sink or suitable pipe.
•
Check that the supplied boiler is the correct model and that it is in good condition.
•
This boiler can be controlled by an external ambient thermostat. Remove the wiring bridge from the internal connector
and replace it with the thermostat wiring.
•
1.16 Install the boiler in such a way the maintenance and repairing works could be easily made.
Summary of Contents for CPE
Page 11: ... 11 NOTAS NOTES ...